High beam headlight & Low beam headlight: 9007 Or, you could check the Bulb Replacement Guide to identify the bulbs in your vehicle. You may want to check your Owners Manual to confirm which bulb you need. Just trying to save others some unnecessary grief.Need to change a bulb in your Ford Ranger, but don’t know what bulb it takes? Here are the bulbs used by the 1983-2011 Ford Ranger. I was able to use the foam gaskets that came with the OEM retainers with the aftermarket ones, and I don't know where to get those separately, so except for time, it wasn't a total loss. (Hatch handle covers pop off - two 9/32-inch head screws under each one, about a dozen retaining clips on the hatch trim, 3 T40-head screws on the latch.) I ended up having to remove the hatch trim panel and the latch mechanism to get them back out. They can't be used in any case without trimming them, which I wouldn't recommend. Typically they will get stuck at this point and will be difficult to remove.

The Ford fasteners protrude about 1-inch behind the panel and beyond 3/4-inch they will contact a structural reinforcement that is part of the hatch structure. However, if you try to use the OEM gray Ford retainers that are used for the upper screws, you will have major problems.

Any AFTERMARKET (I prefer Dorman, but Bell works also) THIN retainer will work just fine. The rubber spacers do pop out easily and Ford did use a standard square cutout for them. That is only PARTIALLY true (at least on a hatchback, not sure on a sedan). Someone here recently posted that is was possible to remove the rubber spacers and use standard plastic nut retainers to secure the Focus rear license plate using 4 screws.

2011 ford edge front license plate